Campbell & Archard Ltd.
Specialist In Early Viennese Clocks
Established 1970.
Tel.(01732)358986. Fax.(01732)771842.
To Contact us click
here.
|
2707 An exceptionally rare mahogany floor standing Laterndluhr. The case takes the form of a typical Laterndluhr wall clock standing on a solid mahogany base. This in itself is quite unusual as many of the Viennese clocks had a longer trunk which then went straight into the solid base. The hood of the clock, which slides off, has a deep ormolu bezel and a domed glass opening door. The pedimented top is strung with boxwood, as is the bottom of the hood where it goes into the slimmer trunk. The trunk has a typical round topped lift out door, again with boxwood stringing to the sides and the edges, and there are glass panels in the side. The glazed bottom box of the clock has a lift out front door and glazed panels to the side, again all strung in the usual fashion. The clock then goes out via an angular boxwood strung moulding into the main plinth which finishes in a secondary plinth. The quality of the veneers throughout is very fine with wonderfully chosen flames for the base, all the mouldings and the backboard. The year duration movement has all of the wheel work mounted on bridges and cocks on the backplate and all the bridges and cocks are nicely fretted out. This style is reminiscent of some of the earlier makers and means that the whole movement is contained within a brass enclosed canister. The clock has a massive true gridiron pendulum and a large brass weight which runs down behind the pendulum. |
![]() Click here to enlarge picture |
![]() Click here to enlarge picture |
![]() Click here to enlarge picture |
The skeletonised dial is surrounded by a deep engine turned and fire gilded bezel and has a fire gilded inner bezel with a small seconds ring fixed to the movement plates via pillars. The movement is mounted into the clock on a massive mahogany block which itself is beautifully veneered with flame veneers. On top of this block is a substantial mounting bracket onto which the movement latches. There is a cutout in the bottom of the block to enable the pulley to go right up into the block, presumably thus gaining the little bit of extra drop required for the year duration. Interestingly, this could have been achieved just as well by cutting a hole in the base board which is mounted below the glass section and, therefore, the drop does not utilize the trunk of the clock at all.
![]() Click here to enlarge picture |
The maker, Dorfer in Wien, is not noted in any of the books, although a clock signed Dorfer in Wien is shown on page 184 of the Kaltenbock book, pictures 399 and 400. Interestingly, this clock has an almost identical method of mounting the movement in the case. It is possible that the signatures on both of these clocks have been miss spelt and should in fact be Dorer in Wien who was a noted maker from about 1820.
Year duration floor standing clocks are always rare and those with skeletonised dials are exceptionally rare.
Height: 6' 4" (193 cms.)
Sold
![]() Click here to enlarge picture |
![]() Click here to enlarge picture |
![]() Click here to enlarge picture |